focus header

[OGreaTFuzzY1]

i went to the junk yard and found a decent stock focus header. whats needed to make it fit our car. im thinking of cutting the piece that attaches to the block and wield ours on. im not in the mood to buy a 200$ header lol

~Fuzzy

[gt35r zx2]

no need to do that bolt right up , great for turbo

[Waterboy9000]

as long as it has a zetec in it, the header will work great for a turbo setup. You can just drill four new holes or cut the end for a flange

[Unlikely Hero]

Depends on what turbo your going with. Decide that and tell us and we can go from there.
=Jason-

[ZX2guy19]

I think he is wanting a header, not a turbo manifold. Not sure though.

[Waterboy9000]

well its in forced induction, so we can only assume

[ZX2guy19]

Ah good point. However, it is an auto so I doubt it, maybe he just wasn't sure. Only time will tell. :]

[OGreaTFuzzY1]

:p i was planing to use it as a header for now till i get some money up to piece one together. :p i dont care if its an atx ill make it a turbo to piss local people off. :twisted: not like im gonna drag race or anything lol.

~Fuzzy

[Beodude123]

What happened to the NA build??

[Beodude123]

Ooops, wrong guy. I thought you were Spyke for some reason for a second.

[OGreaTFuzzY1]

jajaja thats kool homie

~Fuzzy