ecm programmer

[Bluezx2]

anyone know anything bout these or ever heard of them.




2003 Ford Escort ECM Programmer
Brand: Hot Tools
i-Flash 2534 Global On-Board Programmer Hardware (Software Sold Seperately, Part Number BXGM35003) -- Stop Sending Your Customers To The Dealer! The i-Flash Lets you replace or recalibrate ECMs. Updating calibrations are the "21st Century Tune Up" that often correct DTCs that are set incorrectly, transmission shift points, timing issues, fuel economy and many other driveability problems. The i-Flash 2534 Global Programmer is a J2534 compliant passthrough reprogrammer and can be use on nonJ2534 systems. Connect it to you PC, download the latest updates from the manufacturer and upload to your customer's vehicle. Capabilities: GM TIS 2000 Programming, SAE J2534 Programming, Chrysler Programming including VIN and Mileage. Supported Protocols: ISO 9141, ISO KWP 2000, SAE Ji850 PWM, SAE J1850 VPW, CAN, SCI SAE J2610, GM 8192 UART. Software Sold Seperately, Part Number BXBD35721

[LiveWire]

If it could download, maybe you could download a NGP0 to upload to other PCMs.

[ChillinZX]

When I was a tech at Ford I tried to recalibrate my PCM to CWQ3 and it wouldnt work. Hardware has to match the Software.

[Twiggy2cents]

When I was a tech at Ford I tried to recalibrate my PCM to CWQ3 and it wouldnt work. Hardware has to match the Software.

did you try it by as built data or just module reprogramming?

[ChillinZX]

module reprogramming with the WDS machine. I even put in an S/R Vin and it still wouldnt write to my PCM.

[Twiggy2cents]

hmm i wonder if you got the as built data for an s/r and put it into a normal pcm...i miss the wds the laptop ids sucks a lot...but then again my dealership isnt blessed with a toughbook