Newbie question! Remove cubby?

[Spyware]

Howdy! I have yet another newbie question. I'm trying to remove my cubby so I can make a couple modifications to it, though I do not know how to get it out. I took the plastic pins out of both sides of the center console under the dash.. No luck. Couldn't figure out where to go from there. Any help? Pics would be appreciated.

[JoshDank]

there are 2 screws on the rear center console section (near the rear cupholder). After removing those, pull that section off and you will see 2 more screws at the rear of the center console section that houses the shifter. Remove those screws, and you should be able to pull the front section of the center console straight back to loosen it from the cubby and radio area. after you remove that, the cubby will pop out (it's just clipped in).

[00zx2s/r]

you have to take out the whole center consol. You must take the screw out on both sides of the back piece (the one "connected" to center console). Then pull your e-brake up, and lift on the back piece. It will latch off the piece around the shifter and with a lil wiggling you can pull that out over the e-brake handle.

Then there are 2 more screws on the now visible area of the piece around your shifter at the bottom. Take those out, take out the push pins next to the leg area. Take off your shift knob and pull the piece out, then up. Again with a lil wiggling you can get it.

Now you can pull the cubby out. That part just pulls right out.

It may seem like a lot of work, but it only takes like 5 minutes at tops!

[00zx2s/r]

dang Josh you beat me to it! lol

[JoshDank]

lol. between those 2 long posts you should have it taken care of.

[00zx2s/r]

haha basically..... hopefully!

[Spyware]

Awesome. Thanks for all the help. I'll be trying this tonight. =)

[00zx2s/r]

let us know if it doesn't work out! Or just if you got it or not