Forum: Interior and Electronics

Mods please move this to tutorials please, thanks Ok, so you can spend $45+ on gauge overlays depending on how fancy/cheap you buy. Or if your...

This is a very basic remote start/keyless entry install. I cannot cover every possible situation in this how-to. Anyone that has a general knowledge...

1. Set the temp controll to all the way on Cold. Unhook the Temp Controll Cable Next to the Gas Pedal. Theres a white Tab Sticking out push on it...

Again, found this saved on computer. You will need to download both unless u only want to finish it half way!!! lol *Am not taking credit

This covers how to install an electric sending unit for an oil pressure gauge. Since this how-to involves removal of the altenator to reach the...

has anyone removed it or tried taking it off the windows. i want to get it off the front driver/passenger windows

http://www.ford-forums.com/ford-escort/4569-2000-ford-escort-constant-control-relay-module-ccrm.html Cut and paste. I had to post this...

High & low beam headlamp 9007LL 9007SU Silverstar ULTRA for Ultra Night Vision - The Whitest and Brightest Halogen 9007ST Silverstar High...

1. There is a philips screw on both sides of the rear section of the center console. Slide the seats forward for access. - The rear section will...

For the most part its quite simple. It comes out as one big assembly. You could probably find it by searching but i'll try to remember most of it. ...

Since I've read a few times about ppl looking for CCRM info I figured I'd post And I saw the PCM pinout but had a hard time reading it although it's...

Not done for a ZX2, but it could be. ;) http://forums.neons.org/viewtopic.php?f=51&t=200509 ...

It looks hard but it is very simple: Tools: 1. Phillips screwdriver 2. Flat head screwdriver 3. Cutter 4. Long nose pliers Instructions:

click on the link. http://teamzx2.com/zx2connectors.pdf

8-pin connector at the amp, input from stereo: Black - LF(-) White - LR(-) Brown - RF(-) Yellow - RR(-) Green - LF(+) Red - LR(+) Pink - RF(+)...

Custom Sail Panel Tweeter Pod How-To This is a very fast way to make a set of custom sail panel tweeter pods. These take no longer than a full...

Here you go... I was trying to figure out which PCM wires to use when I'm going to plug my Apexi AVC-R Boost controller, so I thought I would just...

Ok, many of you have wondered how to make a custom A-Pillar gauge pod. Well, here is a how-to that I put together exclusively for TeamZX2. The look...

Gauge Pod Cubby How-To First you need to gather the material that you will be using in this project. Here is the list: ·(1) Plastic Drop...