Forum: Service Items

IMPORTANT The ZX2 Zetec is a non-interference engine. This means the valves are not capable of touching the pistons at any time. If your belt...

This is my first attempt at a video how-to, so try not to laugh at me too much. I made a high and low quality version. The video has the rear...

P0100 Mass or Volume Air Flow Circuit Malfunction P0101 Mass or Volume Air Flow Circuit Range/Performance Problem P0102 Mass or Volume Air Flow...

Having issues with your blower motor not working or working intermittently? The most likely cause is a burnt electrical connector at the blower...

heres a how to on programing the key fobs.. can a mod sticky this if needed? Cycle ignition from OFF to RUN or ACC eight (8) times within 10...

Tools. * Jack and jackstand * 8 and 10mm box end wrenches * 8, 10, and 13mm sockets * 3/8" drive rachet and breaker bar * Hammer and long...

The following is the procedure I use to get headlights as clear as new. Tools needed: Foam Sanding Block 400 Wet-sand Paper 600 Wet-sand Paper...

Usually you'll know this part needs to be replaced when your car starts to make a speed related noise that sounds like someone is driving Bigfoot...

Here is a guide to replacing your fuel filter on a ZX2. Tools needed: Screw Driver Nitrile gloves 10 mm Wrench

This how-to will show you how to replace the starter on your ZX2 without even jacking the car up. Of course, if you have large hands, you'll...

http://i48.photobucket.com/albums/f235/importfrk03/beltroutingdiagram.jpg

http://www.teamzx2.com/showthread.php?t=248 Since that how-to also belongs in this section, I'm linking it from here.

How to change your Throttle Position Sensor. Step 1 Remove intake ...

Recommended Lubricants, fluids and capacities. Oil 5w-30 Capacity 4.5 quarts Brake Fluid Type

I'll be working on this a little at a time. I'm still working on the ATX/MTX removal/installation video. Link to video:...

Things needed -------------------- - Socket set - cresent wrench - jackstand/s - Paper and pencil - Tape measure

This is a pdf I made to help with problem diagnosis it lists the symptoms, possible causes and actions to take. It's a 75 page PDF file here...

don't remember where I got it. But found it useful enough to save!

Here's a chart to help you with your spark plugs.

Cleaning the MAF In order to clean the sensor wires, you must remove the MAF from the car. Once removed, spray some electrical contact cleaner or...