Forum: Service Items

Things needed -------------------- - Socket set - cresent wrench - jackstand/s - Paper and pencil - Tape measure

P0100 Mass or Volume Air Flow Circuit Malfunction P0101 Mass or Volume Air Flow Circuit Range/Performance Problem P0102 Mass or Volume Air Flow...

Usually you'll know this part needs to be replaced when your car starts to make a speed related noise that sounds like someone is driving Bigfoot...

I'll be working on this a little at a time. I'm still working on the ATX/MTX removal/installation video. Link to video:...

here's a vid i made...ask if you have questions! i can always go back when i have a spare set of hands to record and show me making the adjustments...

This is my first attempt at a video how-to, so try not to laugh at me too much. I made a high and low quality version. The video has the rear...

Having issues with your blower motor not working or working intermittently? The most likely cause is a burnt electrical connector at the blower...

heres a how to on programing the key fobs.. can a mod sticky this if needed? Cycle ignition from OFF to RUN or ACC eight (8) times within 10...

Tools. * Jack and jackstand * 8 and 10mm box end wrenches * 8, 10, and 13mm sockets * 3/8" drive rachet and breaker bar * Hammer and long...

The following is the procedure I use to get headlights as clear as new. Tools needed: Foam Sanding Block 400 Wet-sand Paper 600 Wet-sand Paper...

Here is a guide to replacing your fuel filter on a ZX2. Tools needed: Screw Driver Nitrile gloves 10 mm Wrench

This how-to will show you how to replace the starter on your ZX2 without even jacking the car up. Of course, if you have large hands, you'll...

http://www.teamzx2.com/showthread.php?t=248 Since that how-to also belongs in this section, I'm linking it from here.

How to change your Throttle Position Sensor. Step 1 Remove intake Step 2 Locate the TPS

Recommended Lubricants, fluids and capacities. Oil 5w-30 Capacity 4.5 quarts Brake Fluid Type

This is a pdf I made to help with problem diagnosis it lists the symptoms, possible causes and actions to take. It's a 75 page PDF file here...

Cleaning the MAF In order to clean the sensor wires, you must remove the MAF from the car. Once removed, spray some electrical contact cleaner or...