Got a clunk? Let others try to help diagnose it.
You can use this database to check your DTC (Diagnostic Trouble Codes) that are pulled from your PCM. http://www.iequus.com/Dtc DTC Team ZX2...
use the link below.... http://search.ebscohost.com/Login.aspx?lp=login.asp&ref=&authtype=ip,uid username: library userpass: library for...
ok so today while driving my oil light came on so i immediately went to the nearest auto parts store and bought oil i put two quarts and the car...
Here's the scenario. I have a 98 zx2 5spd. I have owned it and a blue 98 since purchased new. 6 yrs ago roughly, i got raked on the drivers side...
My Zx2 turned off on the freeway this morning after the lights began to dim and the car started shuttering. I got a new battery and alternator...
I have a blue superchip, run high test and have a K&N intake. The filter is dirty but nothing extreme. My tech buddy looked at it and said it...
New to the forum, just purchased my first ZX2, bought a red 2000 s/r with 99k last weekend. Car runs and drives great, but has a weird idle. The...
So I need a little guidance on a few issues. 1. Rear driver's brake will not adjust much. The adjustment screw turns, but not very smoothly. No...
I just picked up an inexpensive 99 ZX2 that I hope will be my car for the next few years. I look forward to making it my own and becoming part of...
I can't figure this one out... The car starts and then sputters until it shuts off, unless the engine is warn from just having been running, then...
ive had code p0340, cam sensor, and p0171 lean bank 1 intermittent now for a few weeks. ive redone the timing and its in spec. but when i ground to...
Today, I jump in the car and drive away. I instantly notice the brakes are super spongy and I have to put the car in neutral and pull the e-brake...
So my ZX2 has been sitting the last 2 months and Ill take it out and drive it around once every week or so. Well I replaced the valve cover gasket...
I took my valve cover off to clean it and paint it when I found a major issue. My timing belt is missing chunks of rubber on its outer edge and the...
ok so my alternator recently went out about 4 months ago. i bought a new one at autozone. was like 150 sumnt idk well its been working great. last...
Name that sound! How bad is it, guys? My mechanic said he couldn't hear anything. I say, baloney. This is the serp belt, right?
Alright, I searched on both of those codes, and couldn't find a straight answer for either. For the P1451, I took a look at the EVAP thingy in the...
Anyone got any idea what the hell this one is? TexasZx2 found it somewhere, but all it says is "Network Communications" Google comes up Empty,...
So I was backing out of a parking spot and the left cb joint shattered. Im replacing the whole cb joint/ axle assembly and my question is: How do I...
Haven't posted here for awhile. The problem I just ran into was my dome light would randomly not work/work. I had an LED bulb in it and wasn't...
Well I was heading over to a friends house to give his car a jump. I hooked up the jumper cables and I gave my car some gas, I noticed my car started...
Ive put 2 Dayco belt tensioners on my escort..they appear to be causing the belt to run crooked and chirp like crazy..its definitly cocked about 16ht...
My dad fixed the 2 touching wires that go to the VCT solenoid. He put friction tape around them, and theres no bare metal to metal contact now. ...
not cute cats but CATALYTIC CONVERTERS!!!! i burn one a year. im sure its my header that burns them up but i dont know. any ideas should i change...
2 days ago my clutch pedal started acting up. It started as I was pulling away from a dead stop and the clutch engaged with little release of pedal...
so all i wanted to do was install a tranny cooler on my 98 zx2. spliced it between the return line (bottom) and radiator. now i got transmission...
hey evryone, this has been a problem since i got the car, the airbag light in the dash is on. The owner said it needs an airbag sensor. My uncle...
There are currently 3 users browsing this forum. (0 members & 3 guests)
Use this control to limit the display of threads to those newer than the specified time frame.
Allows you to choose the data by which the thread list will be sorted.
Order threads in...
Note: when sorting by date, 'descending order' will show the newest results first.
Forum Rules
